Overhead Hot Crane

Elevator Accessories

As we know that elevators are used for the shifting of goods and passengers to different levels. To build up an elevator, the need to using some elevator accessories is indispensable. So, here are the different types of elevator accessories used for different types of elevators.

ROK-Lift

To take a large load of ROKs to a higher level, a Rokenbok construction is done by the Rokenbok elevator accessory, which is called the Power ROK-Lift. Similar to the RC Elevator, the ROK-Lift operates in an elevating mechanism; it has a plate on the front that is used as a button. With the grooved edges designed for the RC Elevator and the ROK Lift, the mechanism contains gears that can ride along "Elevator Racks", a Rokenbok piece. On either side of the lift module, an RC vehicle dumps ROKs into a storage bin and then bumps into the button to start the motion of elevator; the bins are automatically dumped into a receiving chute or container, and the module is returned to the bottom, once the module reaches a cap piece.

Night Shift Trailer

A trailer that can be driven to the desired location and can be hitched on by any Rokenbok vehicle is called Night Shift Trailer. The trailer is mainly a sign of highway construction that is meant to direct RC vehicles out of the construction site. The sign features two LED direction lights and two LED  flood-lights, which point to left, right, or both the ways. Usually, the LED lights are activated by hand.

Motorized Conveyor

A motorized device which carries ROKs up is called as the Motorized Conveyor. This elevator accessory is of 12 inches. There is a spinning wheel consisting of grooves that push the ROKs to prevent them from getting stuck, and through which they can be fed into the lift. The original Conveyor belt come in the version of A/C plug, where for plugging in the motorized conveyor accessory; a command deck is needed with an "elevator accessory" port. Soon, Rokenbok created a Motorized Conveyor operated by battery to save electricity, eliminate wires and also to use at times of power fluctuations.

Action Sorter

The top of the set of Pump Station Start was the Silo, as well as the Piston Plan for different start set. To raise and lower bins, the silo was used in a vehicle forth. It was also used to push a hanging arm while driving back. ROKs are moved from ramp to ramp by these bins in two different paths. One path would slowly release ROK to one corner, and the other path would dump the ROKs to a fast chute below.